You can prepare instrument easily.

Tissue is used for wiping water and grease.
Alcohol is used for removing grease.You can purchase fuel alcohol in pharmacy. Instead of alcohol, you can use special solvent for removing grease.
Mister/ spray
Scraper is used for remove air when you attach sticker.
Dryer
By low air temperature, sheet becomes hard and wrinkles are made when you attach sheet.
In this case, by using hot air of dryer, you can remove wrinkles and attach. It's better for you that you don't use dryer at first but use dryer when you really need in this process. You can also use dryer for finish.

Before attach seat, wash your car to remove dust and dirt.
Caution: Wash not only car's operation places but all the places where you touch when you attach sheet.
Remove old sticker before you attach new one.
Never waxing when you attach sheet.
If there is a deep blemish, you use water proof abrasive paper or polish and make the blemish flat.
Refrain from damage your bike, you try to use other place which is not outstanding before you use water proof abrasive paper.

Though it looks clean, oil and wax are definitely on the car.
Sheet is easily removed if the bike includes oil content, so please remove the oil carefully.
Folds a few sheets of tissue and put alcohol in it. By using this tissue, you wipe all places where you attach sheets.
If you can't remove wax by alcohol, you use parts cleaner.

Caution, coating car and old gas tank include alcohol. First you try to remove oil in back or shade place so you can see how it works.

It's hard to decide places where you attach sheets. So you can try to attach and remove many times in different places before you decide the best place.
By spray water on the car, attaching strength becomes weaker and the sheet can easily be removed and replaced. Before you decide the best place for the Kit, you spray water on your car and try to attach many times.
Do not care if a drop of water comes out when you use spray.

Attach sheet on the car which is wet by spray.
You can decide good place by attaching verge and hole (Depend on your car's shape).
Do not attach all parts at once. You can remove and attach again and again so you can decide the best place.
Do not push the surface of sheet but just put it on the car, so air does not come in and you can attach the sheet nicely.

After you decide the best place to attach sheet, you remove air bubble by scraper.
You press the center of the sticker first, and move hand to the corner.
You need strength to press the sheet, but if you press too strong, wrinkles are made. So even pressure is suggested to avoid wrinkles.
Make bubble as much as you can in this procedure.
Bubble and ball of water disappear soon.
If you make winkle, use dryer and pull the sheet to the corner.

You don't need special skill or knowledge for attaching sheet.
If you want to change another sheets or you brake the sheet, you can easily replace it with another new one.